Fully Automatic Water Level Controller Circuit Board With Dry Run Protection

Mandatory Requirements:

• You will need two vertical or side-mount magnetic float switches (normally open type) or SS metal sensors and one dry run sensor(if required).
• Transformer to be used: 0-12V or 0–15V or 0-18v or 7. 5–0–7. 5V or 9-0-9v, 1A

Board Size: Approx. 9.5 x 6.5 cm

Saves water, time, power, motor

View Circuit

100% Sаfе due tо thе uѕаgе of flоаt ѕwіtсhеѕ

Fully Automatic Water Level Controller Cum Indicator With Motor Dry Run Protection and top, bottom, flow indicator.

Features:

• Turns off the motor when the water reaches the top level.
• Turns off the motor when there is no flow of water into the overhead tank
• Turns on the motor when the water level falls below the bottom level
• Top, Bottom, Flow indicator
• Power on and Motor On indicator.
• Low-cost ready-made board.
• Works with magnetic float switches.
• Step Down Transformer based design
• Safe magnetic float switches
• No passage of current into the water or no chemical reaction inside the water.
• No corrosion due to the usage of float switches.
• Shows top, bottom and flow indications even if the motor is turned on using the manual switch.
• Semi-automatic on/off option available.
• Manual/Auto Switch option available.
• Device on/off switch option available.